Compliance

Compliance

4 min read

4 min read

IPC/WHMA-A-620 Class 3 vs. Class 2: Which Class Does Your Program Need?

IPC/WHMA-A-620 Class 3 vs. Class 2: Which Class Does Your Program Need?

By TRS International Manufacturing

By TRS International Manufacturing

IPC/WHMA-A-620 Class 3 vs Class 2: Which Standard Does Your Program Need?

IPC/WHMA-A-620 is the workmanship standard that governs cable and wire harness assemblies. It defines three classes, and choosing between Class 2 and Class 3 is one of the first decisions a program has to make, because it affects cost, inspection criteria, and who is qualified to build your hardware.

What separates the classes

Class 2 covers dedicated service electronics where extended life is expected but failures are not catastrophic. Class 3 applies where the assembly must perform without failure: flight hardware, life-supporting medical devices, and defense systems. The physical acceptance criteria tighten accordingly: crimp condition, strand damage, solder fillets, and shield terminations are all judged against stricter limits.

What Class 3 changes in practice

Building to Class 3 is less about a certificate and more about habits: trained and certified operators, calibrated crimp tooling with validated pull forces, documented process controls, and inspection at magnification. If your assembly house treats Class 3 as a checkbox rather than a discipline, the difference shows up in the field.

When in doubt, ask a candidate supplier how many of their operators hold current A-620 certification and who their in-house trainer is. The answer tells you most of what you need to know.

Related: Aerospace & Defense Wire Harnesses

IPC/WHMA-A-620 is the workmanship standard that governs cable and wire harness assemblies. It defines three classes, and choosing between Class 2 and Class 3 is one of the first decisions a program has to make, because it affects cost, inspection criteria, and who is qualified to build your hardware.

What separates the classes

Class 2 covers dedicated service electronics where extended life is expected but failures are not catastrophic. Class 3 applies where the assembly must perform without failure: flight hardware, life-supporting medical devices, and defense systems. The physical acceptance criteria tighten accordingly: crimp condition, strand damage, solder fillets, and shield terminations are all judged against stricter limits.

What Class 3 changes in practice

Building to Class 3 is less about a certificate and more about habits: trained and certified operators, calibrated crimp tooling with validated pull forces, documented process controls, and inspection at magnification. If your assembly house treats Class 3 as a checkbox rather than a discipline, the difference shows up in the field.

When in doubt, ask a candidate supplier how many of their operators hold current A-620 certification and who their in-house trainer is. The answer tells you most of what you need to know.

Related: Aerospace & Defense Wire Harnesses

Have a build this applies to? Let’s talk.

Have a build this applies to? Let’s talk.